![]() External scanners include those connecting by Bluetooth, serial cable or snap-on module. This feature configures DataWedge to select an external scanner as the default scanning device immediately upon connection and revert to a built-in scanner when the external scanner is disconnected. For device-specific support notes, please refer to the Integrator Guide that accompanied the unit. Important: Support for decode parameters can vary depending on the scanning device selected. The scanner connects via USB port and cable.Scanners must be configured using SSI over USB CDC.The DS3608 and LI3608 scanners are supported only on VC80 devices running Android.LI3608 Ultra-Rugged USB SSI Laser Scanner.Note: The Zebra computing device wakes from suspend mode when pressing the scan trigger of any supported scanner.ĭataWedge supports the following Zebra USB SSI scanners: Keep Enabled on Suspend - This mode is supported on Bluetooth and pluggable scanners, and might result in faster battery drain than would otherwise be expected while in suspend mode. ![]() If the RS507 does not reconnect after the swap, DataWedge reverts to the current default scanner.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |